2-29
Controls
LEVERS AND PEDALS
SAFETY LOCK LEVER
• Before standing up from the operator’s
seat to, for example, adjust the
operator’s seat, lower the working
equipment to the ground, raise the
safety lock levers to engage the lock
and stop the engine. If any controls
should be accidentally touched when
the safety lock levers is lowered
(unlocked), the machine will suddenly
move and cause serious injury or death.
• Note that the dozer blade, boom swing
and auxiliary hydraulic controls cannot
be locked, even when the safety lock
lever is set to the locked position.
Do not carelessly touch these controls.
• Be careful not to touch the operating
levers when raising or lowering the
safety lock lever.
• Before leaving the operator’s seat, lower
the working equipment to the ground,
raise the safety lock levers to engage
the lock and stop the engine. Also, be
sure to remove the key, lock the door
and covers, take it with you and store it
in a specified place.
LEVERS AND PEDALS
This device is for locking the hoe attachment,
slewing and traveling.
When the lever is raised, the lever stand
springs up and the controls are locked.
THROTTLE LEVER
This controls the engine speed.
(A) .......Low idling
(B) ......Maximum speed
To Next Page
Loading...
