60
CONTROLS
Accessories
(15) DISP(Time/Frequency) button
This system is equipped with a clock which
can show the accurate time. Even if the
radio is off, the clock still shows the time.
(16) PS/AS switch
Push this button 2 sec below will
automatically operates to show the
memorized station from 1 to 6. The signal
scaning start by pushing this button
momentarily. When a station is received the
scaning automatically stops there for 5
seconds FLASHLY and then resumes
scaning. As soon as the desired station is
found, press the this button again.
If you will auto memory push this button
over 5 sec so initiates a scan of the band.
Station frequencies are either stored in
order of low of frequency for FM, or in
sequence for AM, starting from preset
channel 1. If all of the preset channels have
not been filled up after one scan, the
remaining preset channels are left
unchanged, and channel 1 is recalled.
Channel 8 flashes during A.
VOL
PS/AS
BASS
LOUD DISP
M
H
BAND
SEEK
DN
SEEK
UP
TRE
S LOUD DISP
M
H
D
SEEK
DN
SEEK
UP
TRE
L2C006
¡¡
¡¡
¡Set the time
After pressing DISP button, press tuner
button or to correct the time. Press
tuner button
to set the “hour” and tuner
button for setting the “minute”. Set the
time when the time is shown.
To Next Page
Loading...
Need help?
General
