If your boat has a holding tank, the discharge hose from the toilet leads into the
tank, and no through hull fitting or valve is installed on this line. The holding tank
has a capacity of approximately 15 gallons and is located immediately forward
of the toilet under the berth cushions. The tank is fitted with an air vent, which is
located on the port bow just above the rub rail. A pump out hose leads from the
bottom of the tank to a deck fitting (1 ½" I.D. pipe size) located in the anchor
well.
Before using the marine toilet/holding tank system, open the water inlet valve,
place the lever on "f lush" and operate the pump until approximately one gallon
of clean water has been discharged into the tank. Remove the inspection cover
and charge the tank with a proprietary chemical deodorizer-sanitizer fluid, of
which a number are available. The instructions of the manufacturer of this
sanitary fluid, relating to the quantity to be used, should be followed. Replace
inspection cover. The system is now ready for use.
The level in the tank may be checked by the sight gauge if fitted, or by removing
the inspection cover. When full, the tank must be emptied by a pump out station
at a yacht club or marina. As the tank is emptied, pump clean water into it to
flush the system. The tank should then be re-charged with sanitary fluid .
All hose clamps and other fittings should be tightened periodically. When laying
up for the winter, the tank should be emptied and the toilet drained. In salt water
areas, a thorough flushing with fresh water will remove salt from the system.
PORTABLE TOILETS
A variety of portable toilets are available that are suitable for a Tanzer22. The
limiting factors are the dimensions of the toilet well. These are 20" wide x 28" deep
x 15" high. The manufacturer’s instructions concerning operation and
maintenance should be followed.
ICE BOX
Your Tanzer 22 is fitted with a self draining 23/2 cu. ft. ice box as standard
equipment. The ice box drains into a one gallon container below the starboard
quarter berth. Prior to use make sure that the drain hose is fitted to the nipple on
the bottom of the icetray, and that the hose is inserted in the container.
An ice block or cubes should be placed in the ice tray. The container should be
emptied regularly, otherwise it will overflow and flood the stowage area beneath
the quarter berth. If clean ice
is purchased, the ice water may be used to top up the
fresh water tank.
To Next Page
Loading...