4. Cheek block (P/S) (91). Install with open end of block forward using bolts.
Holes should be caulked.
5. Genoa winch (P/S) (92). Disassemble winches by removing the top
retaining screw that is at the bottom of the handle socket. The drum and
socket casting may then be fitted together and removed from the base.
When lifting the winch drum take care not to lose the pawls and springs
within.
6. The winch bases should be fastened to the cockpit coaming in the
position shown, using the bolts provided. The holes should be caulked.
Reassemble winches.
7. Genoa cleat (P/S) (93) . Through bolt to coaming. Caulk holes.
SPINNAKER GEAR
The spinnaker gear shown in Figs. 18, 19 & 19A may be installed are as follows:
1. Spinnaker halyard block (69). Secure to crane (70) with shackle (see
Figure 2a).
2. Topping lift block (76). Fasten to mast with rivets.
3. Spinnaker pole stowage ring (72) . Fasten to mast with rivets.
4. Spinnaker pole track (74) and slide (75). Install on foreside of mast with
rivets and bolts. The round head bolts should be used to secure each end
of the track, thus providing stops for the slide and the possibility of
removing the slide. Drill 13/64" dia. holes for these bolts and then thread
with ¼" tap.
5. Swivel blocks (77). Install three at base of most with rivets; two on
starboard side for spinnaker topping lift and foreguy, one to port for
spinnaker halyard. These blocks allow the lines mentioned to be led aft to
the cockpit.
6. Turning blocks (78). Install three on cabin top with bolts. Holes should be
caulked.
7. Clam cleats (79) for halyard, topping lift and foreguy. Install three on
winch shelf with self tapping screws .
8. Cheek or offset blocks (P/S) (80) for spinnaker sheet and after guy (Figure
19a). Install and through bolt. Holes should be caulked.
9. Spinnaker halyard (64). 68' x 5/16" dia. dacron line with snap shackle.
10. Spinnaker topping lift (65). 35' x 5/16" dia. dacron line with snap hook.
11. Spinnaker foreguy (66). 25' x 5/16" dia. dacron line with snap hook.
12. Spinnaker afterguy (67). 40' x 5/16" dia. dacron line with Brummel hook.
13. Spinnaker sheet (68). 40' x 5/16" dia. dacron line with Brummel hook.
14. Spinnaker pole (71). 8'9" overall.
To Next Page
Loading...