SCREENS
Screens may be installed as follows:
1. The small teak shelves to support the forehatch screen should be cut to
size. These should then be secured to the underside of the teak trim
already installed around the hatch opening, with the screws provided.
2. It may also be necessary to cut a recess in the forward frame to
accommodate the closing hatch .
3. A small hole should be drilled in the center of the forward edge of the
fiberglass coaming of the main companionway. This should be drilled to
accept the split pin attached to the screen which when inserted, supports
the forward edge of the frame.
N.B. Early models of the Tanzer 22 were not fitted with teak trim around the
forehatch and main companionway. Owners of such models wishing to install
screens should request that this trim be supplied with the screens.
To Next Page
Loading...