BlinkerBeam™ Radio Operation Guide
2
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that
may cause undesired operation.
NOTICE
Standard and Low Power
radios cannot be used in the
same network
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisee aux deux conditions suivantes:
l’appareil ne doit pas produire de brouillage, et
l’utilisateur de l’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en
compromettre le fonctionnement
To satisfy ISED Canada RF exposure requirements, Radio must be used at a distance of greater than 20cm from the user, with
the following exceptions:
Radio requires a minimum separation distance of 24cm when used with the Yagi antenna
Radio requires a minimum separation distance of 22cm when used with the Whip dipole antenna
To Next Page
Loading...