Targetmax® V.2.0 Attendance System Hardware Suite Guide
9
8.1.2 Machine No.
Setting Remark
1 - 255
The sole identity No. of the machine in case of
multi online operation
Initial
1
• Be noted the system can not run correctly if there are different devices have
the same Machine No., in this case, confusion will occurs to the software of
“Attendance system” during recording data.
8.1.3 Baud rate
Setting Remark
9600
The communicating baud rate is 9600bps
19200
The communicating baud rate is 19200bps
38400
The communicating baud rate is 38400bps
Initial
38400
•
The Baud rate must be the same as the PC, otherwise it can not realize
communicating
8.1.4 Language
Setting Remark
Chinese
LCD display traditional Chinese
English
LCD display English
Initial
English
Targetmax® V.2.0 Attendance System Hardware Suite Guide
10
8.1.5 Locking delay
Setting Remark
Yes
Output locking control signal after confirmation
No
Do not output locking control signal after
confirmation
Initial
No
• Only after successful login as well as with setting of outputting locking
control signal. It is recommended set “No” if no need.
8.1.6 Auto Shut Down
Setting Remark
No
Do not turn off automatically
1—255
Turn off automatically unless no any operation
exceeding times’ limit, the time unit is “minute”
Initial
No
8.1.7 Time setting
Setting Remark
Time setting
Set the current time of the machine
Initial
Time is the same as the controlling PC during
production, which can be also set in the software
of Attendance system
To Next Page
Loading...