4 – Operation : Writing Switch Events
24 TASCAM DM Automation Guide
Auto Revert Choices:
With
AUTO REVERT — WRITE/TRIM
enabled, the automa-
tion system stops recording switch events automati-
cally on a per control basis, without any need to end
writing manually. In this case, keys stop recording
switch events at different times, depending on when
they were last pressed and depending on the value set
in
CONTROL SENSE TIME OUT
.
In the case of control surface keys, writing ends
when the
CONTROL SENSE TIME OUT
has expired without
a key press.
CONTROL SENSE TIME OUT
allows the con-
trol surface keys to respond as if they are touch-sen-
sitive, even though they are not.
Writing switch events over a Static switch position
simply adds the new switch events. When writing
new switch events over previous ones, the TASCAM
DM automation system provides you with a high
degree of flexibility over when writing will end.
See the diagram below to understand this behavior:
Figure 21: Writing new switch events over previous switch events with Auto Revert enabled
8 sec
8 sec
8 sec
Control
Sense
Timeout
Control
Sense
Timeout
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
1 sec
2 sec 3 sec
4 sec
5 sec
6 sec
7 sec
Existing Switch Events
New Switch Events
Resulting Switch Events
Switch ON
Switch ON
Switch ON
Switch ON
Switch OFF
Switch ON
Switch OFF
Switch ON
Switch OFF
Switch OFF
Switch OFF
Switch OFF
To Next Page
Loading...
Need help?
General
