Tascam QUICK REFERENCE DM-3200 User Manual

List of Figures
TASCAM DM Automation Guide 3
Figure 1: Timecode source selection (showing USB MTC selected) ............................................................ 5
Figure 2: The automation FILES display ........................................................................................................ 6
Figure 3: Automation SETUP screen .............................................................................................................. 6
Figure 4: Naming a mix .................................................................................................................................. 7
Figure 5: Illustration of trim mode behavior .............................................................................................. 10
Figure 6: AUTO SETUP screen ...................................................................................................................... 11
Figure 7: AUTO FILES screen ........................................................................................................................ 13
Figure 8: AUTO CONFIG display .................................................................................................................. 14
Figure 9: Writing a fader move over a previous static fader position with Auto Revert enabled ......... 17
Figure 10: Writing a POD (or encoder) move over a previous static position with Auto Revert
enabled .................................................................................................................................................... 17
Figure 11: Writing a new fader move over a previous Dynamic fader move with Auto Revert
enabled .................................................................................................................................................... 18
Figure 12: Writing a new POD (or encoder) move over a previous Dynamic move with
Auto Revert enabled ............................................................................................................................... 18
Figure 13: Writing a new fader move over a previous Static fader position with Auto Revert
disabled .................................................................................................................................................... 19
Figure 14: Writing a new POD or encoder move over a previous Static position with Auto Revert
disabled .................................................................................................................................................... 19
Figure 15: Writing a new fader move over previous Dynamic fader moves with Auto Revert
disabled .................................................................................................................................................... 20
Figure 16: Writing a new POD or encoder move over previous Dynamic moves with Auto Revert
disabled .................................................................................................................................................... 20
Figure 17: Write to End over previous Static fader position ..................................................................... 21
Figure 18: Write to End over previous Dynamic fader moves .................................................................. 21
Figure 19: Write to End over previous Static POD or encoder position ................................................... 22
Figure 20: Write to End over previous Dynamic POD or encoder moves ................................................. 22
Figure 21: Writing new switch events over previous switch events with Auto Revert enabled ........... 24
Figure 22: Writing new switch events over previous switch events with Auto Revert disabled .......... 25
Figure 23: Writing a new switch event with Write to End enabled ......................................................... 26
Figure 24: Trimming fader moves with Auto Revert enabled .................................................................. 28
Figure 25: Trimming POD and encoder moves with Auto Revert enabled .............................................. 28
Figure 26: Trimming fader moves with Auto Revert disabled .................................................................. 29
Figure 27: Trimming POD and encoder moves with Auto Revert disabled .............................................. 29
Figure 28: Trimming fader moves with Trim to End enabled ................................................................... 30
Figure 29: Trimming POD and encoder moves with Trim to End enabled ............................................... 30
Figure 30: Initial Status and dynamic data ................................................................................................. 32
Figure 31: Initial Status editing ................................................................................................................... 33

Tascam QUICK REFERENCE DM-3200 Specifications

General

Type	Digital Mixer
Channels	32
Motorized Faders	Yes
Inputs - Mic Preamps	16
Aux Sends	8
MIDI I/O	Yes
Phantom Power	Yes
Word Clock	Yes
Outputs - Digital	AES/EBU, S/PDIF
EQ Bands	4-band
Digital I/O	TDIF, ADAT
USB	Yes
FireWire	Optional (with expansion card)
Outputs - Main	2 (XLR)