TROUBLESHOOTING GUIDE
8-3
Model 0736
Troubleshooting Guide
8
14. The barrel walls are
scored.
a. Missing or worn beater auger. a. Install or replace the beater head.
6-1
b. Missing or worn scraper blades. b. Install or replace the scraper blades.
6-1
c. Missing or worn counter beater. c. Install or replace the counter beater.
6-1
d. The machine was placed in Auto
mode before all sanitizing solution
was removed from barrel.
d. Place machine in Auto mode only
after priming is complete and all
sanitizing solution is removed.
5-2
e. Beater assembly is bent. e. Replace beater assembly.
6-1
f. Counter-beater assembly is bent. f. Replace counter-beater assembly.
6-1
15. The product makes a
popping sound when
drawing product.
a. Pump assembled incorrectly. a. Assemble and lubricate according to
instructions in this manual.
6-4
b. Air/mix pump incorrectly seated. b. Check and if necessary, change the
position of the regulator tube to a
position with greater liquid flow (turn it
to the left).
- - -
c. Draw rate is set too fast. c. Adjust draw rate.
- - -
d. Barrel not primed correctly. d. Drain the barrel and prime the
machine.
6-8
Problem Probable Cause Remedy
Page
Ref.
To Next Page
Loading...
Need help?
General
