EasyManuals Logo

Taylor 161 Operator's Manual

Taylor 161
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
6
Model 161Safety
130319
S DO NOT allow untrained personnel to operate
this machine.
S DO NOT put objects or fingers in door spout.
S DO NOT operate the freezer unless all service
panels and access doors are restrained with
screws.
S DO NOT remove the freezer door or beater
assembly unless the control switches are in
the “OFF position.
Failure to follow these instructions may result in severe
personal injury from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
S DO NOT put objects or fingers in fill or
discharge openings. Failure to follow this
instruction may result in contaminated
product or personal injury from blade contact.
S USE EXTREME CAUTION when removing
the beater assembly. The scraper blades are
very sharp and may cause injury.
Access to the service area of the unit is
restricted to persons having knowledge and practical
experience with the appliance, in particular as far as
safety and hygiene are concerned.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
Cleaning and sanitizing schedules are
governed by your Federal, State, or local regulatory
agencies and must be followed accordingly. Please
refer to the cleaning section of this manual for the
proper procedure to clean this unit.
This machine is designed to maintain product
temperature under 41_F(5_C). Any product being
added to this machine must be below 41_F(5_C).
Failure to follow this instruction may result in health
hazards and poor freezer performance.
DO NOT obstruct air intake and discharge openings:
A minimum of 6” (152 mm) on both sides, and 0” in the
rear is required. Install the skirt provided on the right
side of the unit. Failure to follow this instruction may
cause poor freezer performance and damage to the
machine.
This freezer is designed to operate indoors, under
normal ambient temperatures of 70_-75_F
(21_-24_C). The freezer has successfully performed
in high ambient temperatures of 104_F(40_C) at
reduced capacity.
DO NOT run the machine without product. Failure to
follow this instruction can result in damage to the
machine.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor .

Other manuals for Taylor 161

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor 161 and is the answer not in the manual?

Taylor 161 Specifications

General IconGeneral
BrandTaylor
Model161
CategoryFreezer
LanguageEnglish

Related product manuals