To Next Page

To Previous Page

Model 161Operating Procedures

Step 3

While the solution is flowing into the freezing cylinder,

brush clean the mix hopper, the mix inlet hole, and the

feed tube.

Figure 25

Figure 26

Step 4

Place the power switch in the ON position.

Figure 27

Step 5

Press the WASH key. This will cause the sanitizing

solution in the freezing cylinder to be agitated. Allow it

to agitate for five minutes.

Figure 28

Step 6

Place an empty pail beneath the door spouts.

Momentarily open the center draw valve to sanitize the

center door spout. Open the remaining draw valves to

remove all of the sanitizing solution. When the

sanitizer stops flowing from the door spouts, close the

draw valves. Press the WASH key to cancel the W ASH

mode.

Step 7

With sanitized hands, stand the feed tube in the corner

of the mix hopper.

Figure 29

Repeat Steps 1 through 7 for the other side of the

machine.

Taylor 161 Operator's Manual

Other manuals for Taylor 161