To Next Page

To Previous Page

Model 161 Operating Procedures

Step 3

From the freezer door, remove design caps, pivot pins,

draw handles, and draw valves. Remove all o- rings.

Note: To remove o- rings, use a single service towel

to grasp the o- ring. Apply pressure in an upward

direction until the o- ring pops out of its groove. With

the other hand, push the top of the o- ring forward, and

it will roll out of the groove and can be easily removed.

If there is more than one o- ring to be removed, always

remove the rear o- ring first. This will allow the o- ring

to slide over the forward rings without falling into the

open grooves.

Step 4

Remove the large o- rings, front bearings, and guide

bearings from the back of the freezer door.

Step 5

Return to the machine with a small amount of cleaning

solution. With the black bristle brush, brush clean the

rear shell bearings at the back of the freezing

cylinders.

Note: If the drip pan was filled with an excessive

amount of mix, this is an indication that the drive shaft

o- ring of the beater assembly should be replaced or

properly lubricated.

Step 6

Thoroughly brush clean all disassembled parts in the

cleaning solution. Make sure all lubricant and mix film

is removed. Take particular care to brush clean the

draw valve cores in the freezer door. Place all the

cleaned parts on a clean, dry surface to air dry

overnight.

Step 7

Wipe clean all exterior surfaces of the machine.

Taylor 161 Operator's Manual

Other manuals for Taylor 161