Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Operating
Procedures
Sanitizing
Assembly
Sanitizing
Draining
Cleaning
Priming
Disassembly
Brush Cleaning
Rinsing
Operating Procedures
Step 5
When sanitizing solution
starts leaking from the prime
port, close the prime plug.
Step 6
Place the control switch in
the “WASH” position. This
will cause the sanitizing
solution in the freezing
cylinder to agitate. Allow the
solution to agitate for five
minutes.
To Next Page
Loading...
