Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Operating
Procedures
Disassembly
Assembly
Sanitizing
Draining
Cleaning
Priming
Disassembly
Brush Cleaning
Rinsing
Operating Procedures
Step 3
Remove the drip pan from the
machine.
Note: If the drip pan is filled with an
excessive amount of mix, this
indicates that the drive shaft seal
and o-ring should be replaced or
was improperly lubricated.
Step 4
Remove the front drip tray and
splash shield.
To Next Page
Loading...
