Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Operating
Procedures
Disassembly
Assembly
Sanitizing
Draining
Cleaning
Priming
Disassembly
Brush Cleaning
Rinsing
Operating Procedures
Note: Failure to remove, brush clean,
and air dry these items will result in
damage to the related components.
Step 1
BE SURE THE CONTROL SWITCH
IS PLACED IN THE “OFF” POSITION.
Step 2
Remove the handscrews, freezer door,
gasket, front bearing, beater, scraper
blades, and drive shaft from the
freezing cylinder. Take these items to
the sink for cleaning.
To Next Page
Loading...
