Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Operating
Procedures
Cleaning
Assembly
Sanitizing
Draining
Cleaning
Priming
Disassembly
Brush Cleaning
Rinsing
Operating Procedures
Step 5
When the solution starts leaking from
the prime port, close the prime plug.
Step 6
Place the control switch in the
“WASH” position. This will cause the
cleaning solution in the freezing
cylinder to agitate.
Step 7
Place an empty mix pail beneath the
door spout and raise the draw arm.
Draw off all the cleaning solution.
When the solution stops flowing from
the door spout, lower the draw arm
and place the control switch in the
“OFF” position.
To Next Page
Loading...
