Taylor 8752 - Sanitizing

23
Models 8752 & 8756 with Horizon® Pump Operating Procedures
Step 3
Assemble the check valve.
Figure 27
Step 4
Place the o--ring onto the body of the check valve and
lubricate.
Figure 28
Step 5
Place the rubber poppet in one end of the spring. Do
not lubricate the rubber poppet.
Figure 29
Step 6
Attach the opposite end of the spring onto the inlet
fitting of the check valve body.
Figure 30
Step 7
Place the cap over the spring and poppet. Secure the
cap to the check valve body by inserting the locking
pin.
Figure 31