3-4
TROUBLESHOOTING
Model C152 & C161
Troubleshooting
3
14. Product is popping
when drawn.
a. The draw rate is set too fast. a. The draw rate should be set at 5 oz. to 7 1/2
oz. (142 g to 213 g) of product per 10 sec.
15. The Mix-Low and
Mix-Out probes are
not functioning.
a. There is milkstone buildup in the hopper. a. Clean the hoppers thoroughly.
16. Machine operating/
changing modes
without pressing
button.
a. The wire harness is running directly behind the
buttons, causing activation.
a. Remove DEC plate and secure harness
below buttons.
b. The wire harness is pinched between the
control channel and DEC plate.
b. Remove the DEC plate and inspect wires for
damage. Reassemble and ensure wires are
not caught between DEC plate and channel
before tightening screws.
17. The buttons do not
activate when
pressed.
a. The wire harness is disconnected from the
DEC plate or the logic board.
a. Remove DEC plate and verify that wire
harness is connected to DEC plate and logic
board.
Problem Probable Cause Remedy
To Next Page
Loading...
Need help?
General
