Taylor C152 - User Manual

Other manuals for Taylor C152

Service Manual88 pages

Questions and Answers

T
Tina LawsonJul 28, 2025
Why is no product being dispensed from my Taylor Freezer?
- M
  mbrownJul 28, 2025
  There are several reasons why your Taylor Freezer might not be dispensing product. It could be due to: * Low mix levels, indicated by the Mix-Out light being on. Add mix to the hopper. * The power switch being in the OFF position. Switch it to the ON position and press the Auto button. * The beater motor being out on reset. Allow the beater motor to cool, turn the power switch OFF, press the RESET button, turn the power switch ON, press the Wash button, and ensure the drive shaft turns clockwise. Then, press the Auto button. * Incorrect usage of the mix feed tube. Ensure you are following the correct feed tube procedures and using the air orifice properly.
O
oconnorkimAug 1, 2025
What to do if the product from Taylor C152 Freezer is too soft?
- A
  Amber AustinAug 1, 2025
  If the product from your Taylor Freezer is too soft, consider the following: * Adjust the draw rate to 5 oz. to 7 1/2 oz. (142 g to 213 g) of product by weight every 10 seconds. * Be mindful of the freezing cylinder's capacity; the continuous draw rate is approximately 15 cones. * Ensure there's at least 6 inches (15.2 cm) of clearance around all sides of the machine. * Clean the condenser or air filters regularly on air-cooled machines. * Check the water supply and lines for leaks or kinks on water-cooled machines. * Replace the scraper blades if they are bad. * Adjust the viscosity if it's set too warm. * Verify you're using the mix feed tube correctly, including the air orifice.
A
ashlee76Aug 6, 2025
What to do if the product from Taylor Freezer is too thick?
- J
  josephcolemanAug 6, 2025
  If the product from your Taylor Freezer is too thick, it might be due to improper priming procedures. In this case, drain the freezing cylinder and reprime the machine. Another possible cause is that the viscosity control is set too cold. Try adjusting the viscosity.
A
Albert NicholsonAug 12, 2025
Why is the mix in the hopper of my Taylor Freezer too warm?
- C
  Christina HuynhAug 12, 2025
  If the mix in the hopper of your Taylor Freezer is too warm, it could be because the hopper cover is not in position. Ensure the hopper cover is clean and properly placed. Alternatively, the hopper temperature might be out of adjustment, in which case you should adjust the temperature control.
L
laura55Aug 17, 2025
Why is the mix in the hopper of my Taylor C152 Freezer too cold?
- K
  Kenneth KentAug 17, 2025
  If the mix in the hopper of your Taylor Freezer is too cold, the hopper temperature might be out of adjustment. Try adjusting the temperature control.
M
Marvin AllisonAug 21, 2025
How to fix product collecting on top of the Taylor C152 Freezer door?
- S
  Shannon BrownAug 21, 2025
  If product is collecting on top of the freezer door, the top O-ring on the draw valve may be improperly lubricated or worn. Try lubricating it properly or replacing the O-ring.