5-6
USER INTERFACE
Model C302
User Interface
5
The fifth feature will indicate the left defrost time and
which day(s) the defrost will occur.
The sixth feature will indicate the right defrost time
and which day(s) the defrost will occur.
Press the MENU (SELECT) key to return to the
operator menu.
14. Screen F is CURRENT CONDITIONS. This screen
displays the current viscosity and product
temperature for each freezing cylinder. An asterisk
will indicate which side is refrigerating. Press the
MENU (SELECT) key to return to the operator menu.
Note: Viscosity is checked only when the product
temperature is below 40°F (4.4°C).
15. Screen G is FAULT HISTORY. This option provides
a record of the last 20 faults. The display also
indicates the date and time each fault occurs.
Press the AUTO (- ->) and OFF (<- -) keys to
increase or decrease the fault page.
Page numbers are located in the upper right corner
of the display. The most recently recorded fault will
appear on page 1-1. The fault description is listed on
the third line of the fault page.
Press the AUTO (- ->) key to move to the next
screen.The next screen will indicate when the fault
was satisfied.
Press the MENU (SELECT) key to return to the
operator menu.
16. Screen H is RINSE/SANITIZE. This screen allows
the operator to rinse or sanitize the freezing
cylinder(s).
DEFROST TIME LEFT
CYCLE 1
ALL 09:00
+++ --- SEL
DEFROST TIME LEFT
CYCLE 1
SUN 09:00
<- - - ->+++ --- SEL
DEFROST TIME RIGHT
CYCLE 1
ALL 10:00
+++ --- SEL
DEFROST TIME RIGHT
CYCLE 1
SUN 10:00
<- - - ->+++ --- SEL
CURRENT CONDITIONS
L*1200Hd 27.3F
R*2140Hd 27.3F
SEL
FAULT HISTORY 1
02/25/04 08:34
NO FAULT F OUND
<-- --> +++ --- SEL
FAULT HISTORY 2
02/25/04
R SYRUP PRESS LOW 08:33
<-- --> +++ --- SEL
FAULT HISTORY 2
02/25/04 14:06:19
RESTORED FROM FAULT
PAGE 2 + + + - - - SEL
RINSE / SANITIZE
RINSE SANITIZE EXIT
---
LES>----<
To Next Page
Loading...
