Taylor C602 - Page 22

19
Model C602
Systems, Controls and Operations
RESET DRAW COUNTER
The SERVING COUNTER screen is used to check
or reset the number of servings dispensed from the
machine. The SERVING COUNTER will
automatically reset to zero when the machine is
brush cleaned. (See Figure 27.)
SERVINGS COUNTER
LEFT RIGHT
00
> Next
Figure 27
Reset the SERVING COUNTER by selecting the
CALIBRATION symbol
to advance to the next
screen. Select the AUTO symbol
to move the
arrow (>) to YES and select the CALIBRATION
symbol
. The servings counter will reset to zero
and exit back to the Menu. (See Figure 28.)
RESET DRAW COUNTER
Yes
>No
Figure 28
SET CLOCK
The SET CLOCK option allows the manager or
service technician to adjust the control clock date
and time. The date and time may only be changed
after the freezer has been manually cleaned but
before it has been placed in the AUTO or STANDBY
mode. The following message will be displayed if the
SET CLOCK option is selected when the machine is
not in a brush clean state. (See Figure 29.)
SET CLOCK
08:00 04/02/2004
NO CHANGES ALLOWED
> Press Any Key
Figure 29
To change the date or time, select the SET CLOCK
option in the menu. Touch the AUTO symbol
to
advance the arrow from Exit to Change, and then
touch the CALIBRATION symbol
to select the
Change option. (See Figure 30.)
SET CLOCK
08:00 04/02/2004
Change
>Exit
Figure 30
Change the time by touching the AUTO
or
OPTIONAL FLAVOR symbol
with the cursor
under the hour position. Move the cursor to the
minutes by selecting the CALIBRATION symbol
.
Once the correct minutes are entered, select the
CALIBRATION symbol
to advance the cursor to
the month. (See Figure 31.)
SET CLOCK
08:00 04/02/2004
__
>Exit
Figure 31
Enter the correct month, day, and year. Then select
the CALIBRATION symbol
to advance to the
DAYLIGHT SAVING TIME screen. (See Figure 32.)
DAYLIGHT SAVING TIME
ENABLED
> Enable
Disable
Figure 32
The Daylight Saving Time feature, when enabled,
will automatically adjust the control clock for daylight
saving time. To Disable the Daylight Saving Time
feature, select the AUTO symbol
to move the
arrow to Disable. Then touch the CALIBRATION
symbol
to save the new setting.