21
Model C602
Systems, Controls and Operations
Program the AUTO START TIME by selecting the
AUTO symbol
to move the arrow to Change.
Select the CALIBRATION symbol
to advance to
the next screen. (See Figure 37.)
AUTO START TIME
00:00
__
Figure 37
Program the AUTO START TIME by increasing
(AUTO symbol
) or decreasing (OPTIONAL
FLAVOR symbol
) the hour setting above the
cursor. Select the CALIBRATION symbol
to
advance the cursor and program the minutes
setting.
Select the CALIBRATION symbol
to return to the
previous screen with the new time setting displayed.
Select the CALIBRATION symbol
to exit the
screen and return to the Menu.
STANDBY MODE
The Standby option is used only on models which
have the control panel Standby keys disabled.
The STANDBY option is used to manually place the
left or right side in the standby mode during long, no
draw periods. Select the STANDBY screen from the
Menu. Select the AUTO symbol
to move the
arrow up to the left (shake) or right (soft serve) side.
Select the CALIBRATION symbol
to activate
Standby for the selected side.
Repeat the steps to activate Standby on the
remaining side. (See Figure 38.)
STANDBY MODE
LEFT
RIGHT
>Exit
Figure 38
Discontinue Standby operation for either side by
exiting the Menu and select the AUTO mode.
BRUSH CLEAN CYCLE
The BRUSH CLEAN CYCLE option allows the
manager or service technician to select the
maximum number of days between brush cleaning
the machine. The brush clean cycle may only be
changed after the freezer has been manually
cleaned but before it has been placed in the AUTO
or STANDBY mode.
The following message will be displayed if the
BRUSH CLEAN CYCLE option is selected when the
machine is not in a brush clean state.
(See Figure 39.)
BRUSH CLEAN CYCLE
TIME 14 DAYS
NO CHANGES ALLOWED
Press Any Key
Figure 39
Change the number of days between brush clean
intervals by selecting the AUTO symbol
to
decrease the days or the OPTIONAL FLAVOR
symbol
to increase the number of days. Select
the CALIBRATION symbol
to save the setting
and exit back to the Menu. The number of days
displayed on the brush clean counter will change to
the new setting. (See Figure 40.)
BRUSH CLEAN CYCLE
TIME 14 DAYS
Figure 40
Always comply with local guidelines on the number
of days allowed between brush clean cycles.
To Next Page
Loading...
