Taylor c713 - General Installation Instructions

9
Model C713 Operator Parts Identification
081008
Model C713 Door and Beater Assembly
Figure 2
ITEM DESCRIPTION PART NO.
1 HANDLE A.-DRAW-WELDED X56421-1
2 O-RING-1/4 OD X .070W 50 015872
3 SCREW-ADJUSTMENT-5/16-24 056332
4 PLUG-PRIME TWIN 059936
5 O-RING-1/2 OD X 0.70 W 024278
6 NUT-STUD-BLACK 3.250 LONG 058765
7 NUT-STUD-BLACK 2.563 LONG 058764
8 DOOR A.-3SPT*L G BAF*W/PRG X59922
9 VALVE A.-DRAW X59843
10 VALVE A.-DRAW CENTER X62218
ITEM DESCRIPTION PART NO.
11 CAP-DESIGN 1.010" ID - 6 PT 014218
12 SEAL-DRAW VALVE 034698
13 O-RING-7/8 OD X .103 W 014402
14 PIN-HANDLE-TWIN 059894
15 GASKET-DOOR HT 4"-DOUBLE 048926
16 BEARING-FRONT 050216
17 BLADE-SCRAPER-PLASTIC 17L 035174
18 BEATER A.-3.4QT-HELICORE X31761
19 SHAFT-BEATER 032564
20 SEAL-DRIVE SHAFT 032560