6-14
OPERATING PROCEDURES
Models C709 & C717
Operating Procedures
6
Brush-Cleaning
1. Prepare a sink of Taylor-approved cleaning/sanitizing
solution with an active chlorine concentrate of
100 PPM to 200 PPM.
Important! Use warm water and follow the cleaning/
sanitizing solution manufacturer's specifications.
Make sure all brushes provided with the machine are
available for brush cleaning.
2. Remove all O-rings.
3. Thoroughly brush-clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Make sure to brush all surfaces and
holes, especially the draw valve hole in the freezer
door.
4. Rinse all parts with clean, warm water. Place the
parts on a clean, dry surface to air-dry overnight.
5. Return to the machine with a small amount of
cleaning solution. Using the black brush, clean the
rear shell bearing at the back of the freezing cylinder.
Figure 6-46
6. Repeat steps 1 through 5 for the other side of the
C717.
7. Wipe all exterior surfaces of the machine with a
clean, sanitized towel.
To Next Page
Loading...
