38
4. Use the grill cloth to clean the rear grease shield
and the bullnose areas, as needed during operation.
Note: To increase the life of the release sheet, wipe it
with a damp, folded grill cloth a minimum of four
times every hour.
CAUTION: The upper platen surface is
very HOT. To prevent burn injuries, use extreme
caution when wiping the release material sheet.
To Cook in the Flat Grill Mode
1. Press the Recipe key and select the desired
flat item to be cooked.
2. After placing product in the prescribed method,
press the STANDBY button to start the cook
cycle. See Figure 73.
Figure 73
3. Perform the functions that appear on the display
(i.e., sear, turn). Pressing the RAISE button will
cancel the cook cycle.
4. When the cook cycle is complete, the display will
flash the message “REMOVE” and an audible
alert will sound. Remove the product per the
prescribed method.
To Display the Current Status
Note: The actual temperatures may be displayed at any
time, including during a cook cycle.
1. Press the information key . The following
information will be displayed.
S The current grill temperatures for the upper
and lower plates.
S The ambient temperature of the control board.
S The Wash pail key displays the time since
the grill was last cleaned and the length of time
it took to clean the grill.
S The Auto Level key indicates if the grill is
calibrated and the current menu item.
Wipe Down Mode
2. Press the Wipe Down key to enter the Wipe Down
mode. See Figure 74.
Figure 74
3. The following screen will allow you to move the
platen up and down. See Figure 75.
Figure 75
4. Press The Full Clean key. See Figure 76.
Figure 76