29
PAS ratio modify
To modify the PAS ratio to meet different
requirements:
Take the 1 level for example, “45-55 percent” is the
range value, bottom value can be modified, and the
default is 50 percent. Press UP/DOWN to change the
percentage. Short press of MODE is used to select and
enter the controller over-current cut setting. After
setting then short press MODE to go to the next PAS
level ratio setting. After all PAS ratios are inputted,
please hold MODE over 2 seconds to save the
modification and return to personalized parameter
setting page. For the details, please see Attached List 4
in the appendix.
PAS ratio page
To Next Page
Loading...