TBA KM5S-LCD - Controller over-current cut setting; Pedal assistant sensor setting

33
SPS means speed sensor. Press UP/DOWN to select the
quantity of magnet heads (the range is from 1 to 9,
default value is 1) and long press MODE to save the
modification.
Speed sensor selection
Throttle definition
Select Hnd to enter the throttle definition.
Throttle Enable/Disable
HL means throttle load, HL:N means function
disable ,HL:Y means function enable .
When HL=Y, throttle can control the function. Press
UP/DOWN to select Y, and long press MODE to save and
return to the personalized parameter setting page.
Otherwise select N to continue to throttle vector enable
setting.
HL default value is N.