TC Electronic TC 2290 User Manual

5.4 THE MODULATION SECTION
MODULATION
(LJOSC./ THRESHOLD
a |
SPEED DEPTH
FORM SELECT
<SELECT> 'DELAY', ‘PAN or
'DYN' modulation parameter set.
The TC 2290 features 3 different kinds of modulation effects:
1. Delaytime modulations for chorus, flanger, pitchmodulation
and ADT effects
2. Panposition modulations for ‘autopanning’ of the direct -,
the delay signal or both.
3. Dynamic (volume) modulations for tremolo, compress~, expand-,
duck- and gating effects.
The modulations of the delaytime, the panposition and the dynamics is
controlled by 3 sets of modulation parameters. ‘Roll’ between the parameter
sets by pressing <SELECT>. The 3 parameter sets are completely
independent. They just share the MODULATION section to set their very
similar, but individual modulation parameters.
Each parameter set consists of SPEED, DEPTH and WAVEFORM values.
To enable modulation there is a <MOD> on/off key in each of the sections
DELAY, PAN and DYN. This makes the in/out switching of the modulations
effects very easy.
Note that no delaytime, panning or dynamic modulation takes place unless
the corresponding DELAY, PAN, DYN section <MOD> key is on.
(01) <SELECT> KEY
Use this key to select one of the 3 different modulation parameter sets
(DELAY/PAN/DYN). Each time the key is pressed the SELECT LED
display will advance one step and the DELAY, PAN or DYN values
‘appear in the waveform and the speed/depth display.

TC Electronic TC 2290 Specifications

General

Brand	TC Electronic
Model	TC 2290
Category	Computer Hardware
Language	English