TCi MFC A - 2 General Information; Intended Audience; Receiving Inspection; Storage Instructions

MFC Kit Instructions 2.0 General Information
5
2.0 General Information
Thank you for selecting the MFC Filter Kit. TCI has produced this filter for use in many VFD
applications that require output voltage filtering. This manual gives an overview of how to install,
operate and maintain the MFC Filter Kit. Please contact TCI Technical Support or visit
https://transcoil.com/Support for additional information
Intended Audience
This manual is intended for use by all personnel responsible for the assembly, wiring installation,
operation and maintenance of the MFC Filter Kit. Such personnel are expected to have knowledge of
electrical wiring practices, electronic components and electrical schematic symbols. Panel design using
a TCI MFC Filter Kit should be performed with appropriate engineering supervision so the design meets
the requirements based on materials utilized in the construction of the panel, wiring practices followed
by your shop, and the actual ambient conditions of the components for each application.
Receiving Inspection
The MFC Filter Kit has been thoroughly inspected at the factory and carefully packaged for
shipment. When you receive the unit, you should immediately inspect the shipping container and
report any damage to the carrier that delivered the unit. Verify that the part number of the
components you received is the same as the part numbers listed on the engineering drawings for
the kit which can be found at:
https://transcoil.com/products-kmg-mfcdrawings-htm/
Storage Instructions
If the MFC Filter Kit is to be stored before use, be sure that it is stored in a location that conforms
to published storage humidity and temperature specifications in this manual and on the applicable
technical drawings available at: transcoil.com. Store the unit in its original packaging.
TCI Limited Warranty Policy
TCI, LLC (“TCI”) warrants to the original purchaser only that its products will be free from defects
in materials and workmanship under normal use and service for a period originating on the date of
shipment from TCI and expiring at the end of the period described below:
Product Family
Warranty Period
KLR, KDR
For the life of the drive with which they are installed.
HGA, V1K, KLC,
KLCUL, KMG, MSD
One (1) year of useful service,
not to exceed 18 months from the date of shipment.
PFGuard, HGP, HGL,
HG7, HSD, KRF
Three (3) years from the date of shipment.
KCAP, KTR
Five (5) years from the date of shipment.
All Other Products
One (1) year of useful service, not to exceed 18 months from
the date of shipment.
The foregoing limited warranty is TCI’s sole warranty with respect to its products and TCI makes
no other warranty, representation, or promise as to the quality or performance of TCI’s products.
THIS EXPRESS LIMITED WARRANTY IS GIVEN IN LIEU OF AND EXCLUDES ANY AND ALL
EXPRESS OR IMPLIED WARRANTIES INCLUDING, WITHOUT LIMITATION, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
This warranty shall not apply if the product was:
a) Altered or repaired by anyone other than TCI;
b) Applied or used for situations other than those originally specified; or