TCS CS-105 User Manual

DRAFT
2. Under “Access Point Configuration” you can modify the WiFi name and password of the system
when it is set to run in Access Point mode.
3. Under the “Add WiFi” section, you can add WiFi names and passwords for connections you would
like the command station to connect to in Client mode. Press the “Add” button after entering a new
SSID and password to add it to the list of profiles. You can store up to 7 WiFi profiles total.
4. At the bottom of the page is a list of profiles saved in the system. You can click the check box next
to one or more profiles and then press the “Remove Selected Profiles” button to delete those
profiles.
5. After adding WiFi profile or changing the WiFi mode, you have to power cycle the CS-105 for the
changes to take effect.
An example of the configuration window is shown below:
7.4.2 TCS Throttle Based Configuration
You can reconfigure the onboard AP or add new WiFi profiles to the CS-105 through the menu interface of
the TCS throttles. To do this, enter the Menu and navigate to 8 Settings > 2 DCC System Settings > 3 WiFi
Settings.
© 2022 Train Control Systems Page 34 of 49

TCS CS-105 Specifications

General

Brand	TCS
Model	CS-105
Category	Industrial Equipment
Language	English