Teac A-2340 - Page 27

5. At this time you have synchronous but discrete program material on tracks
1 and 3 since the displacement between record and playback head is no
longer a factor to be considered.
The remaining two tracks may be recorded simultaneously or independently
~ and may be synchronized to track 1 or 3 as desired merely by selecting
the track to be monitored. This is accomplished by selecting the SIMUL-
SYNC position for the track to be monitored. Tracks 1 and 3 may be
monitored simultaneously by placing the L1, R3 head function selector
switches to the SIMUL-SYNC position.
7.
Since'all
4
MONITOR
switches
remain
in
the
SOURCE
position,
al]
4
tracks
should
be
recorded
at
the
optimum
reference
level.
That
is
with
the
VU
“meter
indications
centered
at
or
around
the
0
VU
point
on
the
VU
meter
scale.
You
now
have
discrete,
synchronized
program
material
on
all
four
tracks,
obviously
therefore
they
may
be
played
back
simultaneously.
The
sound
mix
or
blending
is
accomplished
during
the
playback
mode.
9.
Any
or
all
of
the
independent
tracks
may
be
erased
and
re-recorded
as
«they
can
be
easily
synchronized
to
any
remaining
track
by
use
of
the
appropriate head function selector switch.
10.
During
playback,
all
head
function
selector
switches
should
be
in
the
NORMAL position.
mma)
e
2)
CAUTION: Again, to prevent the recording of switch noise, never change
the position of the head function selector switches while a
recording is being made. Retard the OUTPUT level control for
the head or channel being switched before changing switch.
position. Do not change switch position while tape is in
motion (recording or playback mode).
ste