Teac A-6300 - 6. PARTIAL DISASSEMBLY

Fig. 6-1 Rear Panel and Bottom Plate Fig. 6-2 Wood Sides
Most amplifier checks and adjustments can be made from the bottom
with the plate removed.
These adjustments should be performed by experienced technicians,
and then only when going through the complete test and check pro¬
cedures on the unit which is being tested.
HEAD ASSEMBLY REPLACEMENT - -
To change the head assembly as a unit, remove the 4 mounting
screws. Note the positions of the wires on the circuit board
before unsoldering. Solder wires of the new assembly in ex¬
actly the same positions. Refer to Fig. 8-3 Head Wiring Section.
Fig. 6-3 Head Assy Removal