16
RECORDING TO USB/CARD
1. Connect a USB or CARD storage device into its appropriate slot on the unit’s front
panel.
2. Press the FUNCTION button repeatedly to select your desired recording source
(PHONO or FM).
3. If you wish to adjust the bitrate setting, press and hold the BIT/REC button for over 2
seconds and wait until '128 KBPS' appears on the display. Press and to select
between 64, 128 and 192 KBPS. Press the BIT/REC button to confirm the setting.
You are now ready to record in your chosen bitrate.
4. To start recording, start the music playback on PHONO/TUNER and press the
BIT/REC button. Recording starts when ‘REC’ appears on the display and the
RECORD INDICATOR lights up.
5. To complete the recording, press the STOP ( ) button again. Recording will stop
and the RECORD INDICATOR will fade out.
NOTE:
If no bitrate adjustments were done, recording will default to 128KBPS. If you do not
want to use the
default bitrate (128KBPS) for recording, be sure to select your
desired bitrate according to the instructions above.
If ‘REC ERR’ appears on the display, make sure your USB/CARD device is plugged
in securely.
If both USB and CARD memory devices are connected to the unit, the unit will
default to recording into the USB device.
Song titles and tag information are not recorded during the encoding process.
If the radio reception is poor, the recording quality from TUNER to USB/CARD will be
affected. Try to get the best reception before recording.
The recorded files are saved in a folder called ‘RECORD’.
Record songs into your USB or CARD st
orage device in the MP3 file format.
NOTE:
This unit supports USB and SD/MMC/HCSD CARD devices up to 16GB and
formatted in the FAT32 file system.
Record to USB or CARD from PHONO/TUNER
To Next Page
Loading...
