26
PCM digital filter
This sets the type of digital filter used when converting PCM signals
from digital to analog.
*PCM D-FILTER
> OFF
OFF
No digital filter is used.
FIR SHARP
An FIR filter with a steep roll-off is used to sharply cut signals out-
side the audio band.
FIR SLOW
An FIR filter with a slow roll-off is used to gently cut signals out-
side the audio band.
SDLY SHARP
A short delay filter with a steep roll-off is used to sharply cut sig-
nals outside the audio band.
SDLY SLOW
A short delay filter with a slow roll-off is used to gently cut signals
outside the audio band.
Note about the digital filter during PCM playback
FIR-type digital filters
This type of filter has an established reputation for sound quality
and features tonal quality with both dense, rich sound reverbera-
tions and crisp sound transients.
SDLY-type digital filters
This type of filter has no pre-echo in the impulse response and
features natural sound attack and reverberation for a tonal quality
that is close to the original.
DSD digital filter
This sets the type of digital filter used when converting DSD signals
from digital to analog.
*DSD D-FILTER
> CUTOFF 150kHz
CUTOFF 50kHz
50kHz cutoff frequency
CUTOFF 150kHz
150kHz cutoff frequency
Display brightness
This sets the brightness of the display.
o Regardless of the brightness setting, however, error messages
will always be shown at normal brightness.
*DIMMER
> DIMMER 3
DIMMER 3
Normal brightness
DIMMER 2
Slightly dim
DIMMER 1
Even dimmer
DIMMER 0
Unlit
o The display stays unlit even when the unit is on.
Level meter operation
This sets level meter brightness and turns operation on and off.
*METER
> DIM3
DIM3
Level meter brightness: bright
Level meter operation: on
DIM2
Level meter brightness: slightly dim
Level meter operation: on
DIM1
Level meter brightness: even dimmer
Level meter operation: on
DIM0
Level meter brightness: unlit
Level meter operation: on
OFF
Level meter brightness: unlit
Level meter operation: off
Settings (continued)
To Next Page
Loading...
