Teac R-3 - Basic Operation; Powering On and Standby; Volume Adjustment; Source Selection

10
Adjust the volume
To protect the speaker from a sudden
high-level signal, gradually turn up the
volume to the required level using the
VOLUME knob.
To turn off the main power (To save
battery)
When the R-3 is not being used, you can
save battery power by turning off the
MAIN POWER switch on the rear panel.
<
While the MAIN POWER switch is turned
off, display goes out but the R-3 can
continue to recharge the battery.
D
C
To turn the unit ON or to standby
Press the STANDBY/ON button.
<
If the MAIN POWER switch on the rear
panel is turned off, press the switch to
turn the unit on.
To select a source
Each time the FUNCTION button is
pressed, the mode is changed as follows.
DAB FM AUX
B
A
Basic Operation
A B
C