TEC MA-516-100 SERIES - 5. Outline of Preparation Procedure Before Operating the ECR

- 9 -
EO1-11116
MA-516-100 SERIES
5. Outline of Preparation Procedure Before
Operating the ECR
This chapter shows the outline of set-up procedure of the ECR before actually starting the ECR operation.
1
Remove the cash register from the carton, referring to Chapter “2.
Unpacking” on page 2. And take out all the parts and accessories.
2
3
4
5
Remove the tapes and seals for holding parts or protecting the
register surfaces.
Plug the power cord of the register into a wall outlet. Make sure that
the outlet voltage matches that of the power required for the
register.
Insert the MA key into the Control Lock.
Turn the Control Lock to the REG position.
OFF Z
REG
X
SET
MGR
-
OFF
Z
REG
X
SET
MGR
-
(1) (2) (3) (5) (6) (7) (8) (9)(4)