TEC MA-516-100 SERIES - Replacing the Journal Roll

- 142 -
EO1-11116
MA-516-100 SERIES
5
Replacing the Journal Roll
1
2
3
TX
M
Turn the Control Lock to the REG position using the
Control Key.
To remove the Printer Cover, insert the Printer Cover
Key to the Printer Cover Lock, and then turn it 90°
clockwise.
Depress the [JF] key to wind up enough of the Journal
Paper, then cut the paper as shown in the figure.
Depress the [JF] key to feed the remaining paper end.
CAUTION: Never try to pull out the remaining paper end
by hand. It may cause a paper jam.
Load new paper roll as described in Chapter 10 on page
16.
OFF
Z
REG
X
SET