TEC MA-516-100 SERIES - Changing the Layout of the Money Case

- 148 -
EO1-11116
MA-516-100 SERIES
2
Remove the Coin Case from the Money Case.
3
4
5
To remove the Partition from the Coin Case, pull the
Partition upward while pushing the Coin Case outward.
Set the Partition in the groove of the place where you like
to set, then push the Partition downward.
To change the layout of the Bill Case, it is necessary to
remove the Bill Holder. To remove the Bill Holder, insert
the tip of the phillips screwdriver in the back of the Bill
Holder, then push the phillips screwdriver downward. To
remove the Partition, pull the front of the Partition up-
ward.
Changing the Layout of the Money Case
1
Open the drawer, then take the Money Case out.