- 17 -
EO1-11116
MA-516-100 SERIES
Press the [RF] key until about 4 inches (about 10 cm) of
paper comes out of the printer.
Attach the Printer Cover, and cut the excess paper with
the attached cutter.
After closing the Printer Cover, depress the [#/NS] key
to check print condition.
TX
M
5
6
7
Insert the paper end into the receipt inlet behind the
printer. Then, feed the paper by hand into the inside of
the printer while pressing the [RF] key provided at the
central upper side of the keyboard until the paper end
comes in contact with the roller (black) as shown below.
If the paper is not fed smoothly, cut the paper end again
to make it sharp, then re-set the paper roll.
<Front View>
Roller (Black)
Paper End
To Next Page
Loading...
