EasyManua.ls Logo

Tech Controllers ST-976 - Fire-Up; Damping; Fuel Tank Full; Temperature Settings

Tech Controllers ST-976
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
4.3.1
Fire‐up/Damping
Oncethisfunctionhasbeenselected,thefire‐upprocessstarts.
Theuserisaskedtoconfirmthefire‐upprocessactivation.
Thenextstagesoffire‐upprocessaredescribedinsection:
Błąd!Niemożnaodnaleźćźródłaodwołania.Fire‐up,page:
10
Itisadependentfeature‐itdependsontheoperationmode.Fire‐
upfunctionisdifferentoperationmodesisdescribedinthefollowingsection:
4.4.12Ecomode,page:39
Oncethefire‐upprocesshasbeenactivatedinthecontrollermenu,thisoptionchangesintoDamping,which
enablestheusertostartCHboilerdampingprocess.
4.3.2
Fueltankfull
Thisfunctionshouldbeusedafterthefueltankhasbeenfullyfilled,inordertoresetthefuellevelto100%.
NOTE
Beforeusingthisfunctionforthefirsttimeitisnecessarytocalibratethefuelfeederoperation.
4.4.10Fuellevelcalibration,page:38
4.3.3
Temperaturesettings
MAINMENU
TEMPERATURESETTINGS

Pre‐setCHtemperature
Pre‐setDHWtemperature
CHboilerhysteresis
DHWhysteresis
Pumpswitchontemperature
Pre‐setroomtemperature*
*Whenroomregulatorisconnected,withRScommunication
Afterselectingagivenicon,thedisplayshowsapanelenablingtheusertochangethesettingusinga
sliderorarrows.
Pre‐setCHtemperature
Thisoptionisusedtodefinethepre‐settemperatureoftheCHboiler.Thesettingrangeavailableis55°C80°C
(thesettingrangemaybechangedbythemanufacturerorfitterintheservicemenu).
Pre‐setDHWtemperature
Thisfunctionisusedtodefinethepre‐settemperatureofthedomesticwater.After thewaterin thetank
reachesthis temperature,DHWpump isdisabled. Thepumpwillbe enabledagainwhen thetemperature
dropsbelowthepre‐settemperatureminusthevalueofDHWhysteresis(readfromtheDHWsensor).DHW
temperaturerange:40°C‐60°C.

Related product manuals