Tech Controllers ST-976 - Fitters Menu; Service Menu; Time Settings


22
Softwareupdate
Thisfunctionisusedtoupdate/changethesoftwareversioninstalledinthecontroller.
NOTE
· SoftwareupdateshouldbeconductedwhentheCHboilerisdamped.
· Thememorystickwhichisgoingtobeusedtosavethesetupfileshouldbeempty(preferably
formatted)
· Makesurethatthefilesavedonthememorystickhasexactlythesamenameasthedownloaded
filesothatitisnotoverwritten.
 Mode1:
 InsertthememorystickwiththesoftwareintothecontrollerUSBport.
 SelectSoftwareupdate(inscreensettings).
 Confirmcontrollerrestart

o Thecontrollerrestarts
o Softwareupdatestartsautomatically.
o Oncerestarted,thecontrollerdisplayshowsthestartingscreenwithmoduleandscreen
softwareversion
o Screenandmodulesoftwareversionsmustmatch
o Oncetheinstallationprocessiscompleted,thedisplayshowsthemainscreen.
 Whensoftwareupdatehasbeencompleted,removethememorystickfromUSBport.

 Mode2:
 InsertthememorystickwiththesoftwareintothecontrollerUSBport.
 Resetthedevicebyunpluggingitandpluggingitbackin.
 Whenthecontrollerstartsagain,waituntilthesoftwareupdateprocessstarts.

o ThefollowingpartofsoftwareupdateisthesameasinMode1.
4.3.11 Fitter’smenu
Fitter’smenuisintendedtobeaccessedbythepersoninstallingtheCHboilerorservicestaff.Itincludes
additionalcontrollerfunctionssuchasCHboilerparameters,additionalvalves,additionalpumpsaswellas
advancedsettingsofbasicfunctions.
 4.4Fitter’smenu,page:24
4.3.12 Servicemenu
Servicemenushouldbeaccessedonlybyqualifiedservicestaff.Inordertoaccessservicesetting,itis
necessarytoentera4‐digitcodeprovidedbyTECHCompany.
4.3.13 Timesettings
SETTINGS
MENU


TIME
SETTINGS


Clocksettings

Datesettings

Thisfunctionisusedtosettime.