APPLYING THE CUFF
1. Remove the watch, jewelry, etc. prior to attaching the wrist monitor.
Clothing sleeves should be rolled up and the cuff should be wrapped
on bare skin for correct measurements.
2. Apply cuff to left wrist with palm facing up as Fig. A
.
3. Make sure the edge of the cuff is about 1 cm from the palm as Fig.
B.
4. In order to ensure accurate measurements, fasten the Velcro strap
securely around your wrist so there is no extra space between the cuff
and the wrist as Fig. C.
If the cuff is not wrapped tight enough, the measurement values may
be incorrect.
5. If your physician has diagnosed you with poor circulation on your
left arm, carefully place the cuff around your right wrist as shown in Fig.
D.
30
To Next Page
Loading...
Need help?
General
