Technicolor TG588v v2 - Connect to service provider network

13
2 Setting up your TG588vv2
DMS3-CTC-25-42 v1.0
2.2 Connecting your TG588vv2 to your service provider’s
network
Introduction
This section helps you to connect your TG588vv2 to your service provider’s network.
Connecting the cables
Proceed as follows:
1 Take the DSL cable. This is the grey cable that is included in your package.
2 Plug one end of the cable in the grey DSL port on the back of your TG588vv2.
3 If your delivery:
 Does not include a DSL splitter, plug the other end of the DSL cable into your telephone wall socket.
 Includes a DSL splitter, plug the other end of the DSL cable into the DSL/Modem port of the DSL splitter. Plug the
(LINE) cable of the DSL splitter into your telephone wall socket.
Only use the DSL cable provided in your package. Other DSL cables may not work with the DSL subscription
that you purchased.
A splitter/filter is a box that typically has the following connectors:
•A Line input
•A Phone/PSTN output
•A DSL/Modem output (optional)
DSL
NickDJ.co.uk