Technicolor TG588v v2 User Manual

21
3 Wireless networking
DMS3-CTC-25-42 v1.0
2 The WPS LED starts blinking orange. This indicates that your TG588vv2 is now searching for wireless clients that are in
registration mode. You now have two minutes to start WPS on your wireless client.
3 Start WPS PBC on your wireless client.
4 Your TG588vv2 provides its wireless settings to the wireless client.
5 At the end of the WPS process, the status of the WPS LED on your TG588vv2 will change to either of the following:
 Solid green
This indicates that you successfully registered and connected this wireless client. You are now connected to your
TG588vv2 wireless network.
 Blinking red
This indicates that your TG588vv2 could not find any wireless client in WPS pairing mode or that the exchange of the
wireless settings and/or registration failed. For more information, see “Cannot connect via WPS” on page 53.
Connect your wireless client using WPS PIN code entry on the wireless client
Proceed as follows:
1 Check the label on your TG588vv2 and note the following information:
 The PIN code that is printed next to the WPS logo.
 The Network Name.
These are the default values. If you already changed these settings, use the new settings instead.
2 Go to the WPS PIN code entry page of your wireless client. Consult the documentation of your wireless client for more
information.
3 Enter the PIN code,
4 Your wireless client may prompt you to select your access point. If this is the case, your access point will be listed with its
Network Name.
Connect your wireless client using WPS PIN code entry on your TG588vv2
Proceed as follows:
1 Locate and note the WPS PIN of your wireless client. For more information, consult the documentation of your wireless
client.
2 Browse to the TG588vv2 web interface.
For more information, see “4.1.1 Accessing the TG588vv2 web interface from your local network” on page 29.
3 Click Wireless. The Wireless page appears.
4 In the WPS Device PIN code box under Access Point, type the PIN code of your wireless client and click Set PIN code.
In case of problems
If you are having trouble connecting your wireless client via WPS, see “Cannot connect via WPS” on page 53 for more
instructions.
Do not include the hyphen when entering the PIN code. For example, if the PIN code is 1234-5678, then enter
12345678.
You can find the default network name on the product label of the TG588vv2.
1234-5678
NickDJ.co.uk

Technicolor TG588v v2 Specifications

General

Device Type	ADSL2+ Modem Router
Wi-Fi Standards	802.11b/g/n
Wi-Fi Frequency	2.4 GHz
WLAN speed	Up to 300 Mbps
Ethernet Ports	4 x 10/100 Mbps
USB Ports	1 x USB 2.0
DSL Interface	RJ-11
Security	WEP, WPA, WPA2, WPS
Weight	320 g
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
ADSL Standards	ITU-T G.992.1 (G.dmt), ITU-T G.992.2 (G.lite), ITU-T G.992.3, ITU-T G.992.5 (ADSL2+)
VoIP	Yes
Humidity	20% to 90% (non-condensing)