Technics QUARTZ SA-R330 - Page 4

SA-R330 SA-R330
* Remote-control transmitter (EUR64758)
on/off 3 muting Vvolume &
Amplifier controls
Power button
Tuner controls
Cassette deck controls
Compact disc player controls
Remote Control Transmitter
EUR64758
WNotes concerning use of dry batteries
© Do not use chargeable batteries (Ni-Cd type).
¢ Be sure the batteries are inserted so that the positive (+)
and negative (—) polarities are correct. Batteries install-
ed with incorrect polarities may leak and damage the
remote-control transmitter.
° Never subject the batteries to excessive heat or flame;
do not attempt to disassemble them; and be sure they are
not short-circuited.
¢lf the remote-control transmitter is not to be used for a
long time, remove the batteries and store them in a cool
dark place.
* Always remove old, weak or worn-out batteries promptly
and dispose of them properly.
Never mix old and new batteries, nor batteries of dif-
ferent types (carbon or alkaline).
2 Insert the batteries and
close the cover.
Use two AAA
[RO3(UM-4): 1.5 V]
batteries.
1 Open the cover.
Bottom panel of remote-
control transmitter
MiTo remove the batteries
Reverse procedure 2.
@ Battery life
About 1 year.
(Depending on frequency of use.)
Operation notes
Face it toward the remote-control
signal sensor.
Be sure the transmitter part of the remote-control
transmitter and the sensor part of this unit are
free from dust. Excessive dust might prevent
reception.
Use the remote-control transmitter
within 6 meters.
Remote-control
transmitter
(Obstacles should
be avoided.)
6 meters (20 ft.)
Notes: 1. The control panel of the remote-control transmitter may be covered by a clear plastic protective sheet. This sheet may be removed if
desired.
2. If this unit is placed in an audio rack, the distance that the remote control transmitter can be used from might be reduced due to the
thickness or color of the glass door.
—5—
Mi CONNECTIONS
¢ Connections to equipment
“PHONO” terminals
Connect a turntable.
Note:
For remote-control operation, be sure to
connect the ground wire correctly.
Turntable (option)
eT
ae
“VCR 1” terminals
Connect a video cassette recorder or an
audio tape deck etc. (Refer to the operat-
ing instructions of VCR, etc.)
Video cassette recorder (option)
(GND)(R) () (L)(R)(Y(R)
G id wi ti
reunite
(onten
Stereo
connection
Stereo
—
cable (option) connection
cables (option)
“PRE OUT/MAIN IN”
terminal (See above.)
This unit (GND)(R) (L) (L)(R)(L)(R)
“PRE OUT/MAIN IN”
terminals
Do not remove the shorting pins from
these terminals unless you plan to use
an independent preamplifier or main
amplifier. (No sound will be heard if they
are removed). To use it in this way,
consult the operating instructions for the
additional amplifier or preamplifier that
you plan to use.
Cooling fan
The cooling fan operates only at high
output power levels.
PRE MAIN
OUT IN
C2
CD
(L) (R)
Stereo
connection
cable (option)
: une out OC) CE) ©
REMOTE
, CONTROL
Compact disc player (option)
“CD” terminals
Connect a compact disc player.
If the remote control terminal on the tape deck is 1/8 inch stereo mini-jack.
This unit
$$
Connection cable for remote-control (included)
(AX (RY
Stereo
connection
cables (option)
~_Flat cable for
(included)
Tape deck (option)
“TAPE/VCR 2” terminals
Connect a tape deck or second VCR.
Tape deck (option)
INPUT OUTPUT
- REMOTE GY ©
CONTROL
—-6-
Connection cable
for remote-control
(included) %
eee || A rr SameEeS
If the remote-control
terminal on the tape
deck Is 3-pin type.
remote-control
Connection cable for remote-control (option)
AC power supply cord
(included)
The configuration of the AC
outlet and AC power supply
cord differs according to
area.
ES I go a ee eee al
!
fe)
| Household AC outlet :
Compact disc player (option)
INPUT
' REMOTEG)
CONTROL
MED