Technics SA-1000 - Page 7

5) Location of antenna
Install the antenna:
1. Where it will receive FM broadcast signals directly;
not in the “shadow” of a building.
Correct location avoids
multi-path reception
Obstruction
= Oe waves
Reflected
waves don't
enter
directional
range
ston
Station
ee
ee waves
Directional characteristic
Note:
Multi-path reception is the distortion which results
from the reception of two types of signals: those re-
flected from nearby buildings, mountains, etc., and
those received directly from the broadcasting station.
2. Away from busy roads, and away from neon signs.
a Away from noise sources!
aN
va i
3. At least 4 meters (12 feet) above the ground (except
in mountainous regions, etc.).
--->
Signals not received
if too low
\
=
=
A
s high as possible
4. At least 3 meters (10 feet) away from a meta! roof or
other antennas.
a aa x
Metal roof eu > "
At least 3m oe
1 1 away
5. To avoid danger, away from electric power lines.
Danger close to power lines
AM ANTENNA
lf an outside AM antenna is installed (in mountainous
regions or between reinforced-concrete buildings), install
it in a location away from utility poles, high-voltage power
lines, high buildings and busy roads.
These terminals are used when this unit is to be used in-
dependently as a pre-amplifier or as a main amplifier.
TO USE THIS UNIT AS A PRE-AMPLIFIER
Connect the pre-amplifier output terminals (‘PRE OUT’)
of this unit with the input terminals (‘INPUT’’) of the main
amplifier, using shielded cable to make the connection.
Record player
Pre-amplifier output
terminals (‘PRE OUT")
Shielded cable (optional)
Main amplifier
Ly
dR
(stereo
power
amplifier
Input terminals
("INPUT")
TO USE THIS UNIT AS A MAIN AMPLIFIER
Connect the main input terminals (‘MAIN IN’’) of this unit
with the output terminals (“OUTPUT”) of the pre-amplifier,
using shielded cable to make the connection.
Shielded
cable
(optional)
Output terminals
("OUTPUT’’)
Main input terminals
(“MAIN IN’)
Connection pins:
Remove only when this unit is used as
a pre-amplifier or main amplifier.
Be sure the power switch@ is “OFF”
before removing the connection pins.
PRE CLIT MAUN IN