Technics SA-AX540 User Manual

Specify the frequency using the numbered buttons on the remote
control to directly tune to the station.
1 Press [TUNER/BAND].
This will set the remote control to operate the tuner.
The selector on the receiver will change to “TUNER”.
Each time the button is pressed, the band will change as
follows,
FM AM.
2 Press [DIRECT TUNING/DISC ENTER].
3 While cursor display is flashing (approx. 10 seconds)
Press the numbered buttons to enter
the frequency.
If the desired FM frequency is 107.9 MHz, press
rn —>2]—>[7]—
If the frequency has been input correctly, the displayed
frequency will blink once.
I7HEI
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received.
To re-specify the frequency, repeat the procedure from
step 2.
2. If the frequency has not been input correctly, “ERROR"
will be displayed.
In this case, re-enter the frequency.
17
RQT5212
Radio
functions

Technics SA-AX540 Specifications

General

Tuning Range	FM, MW
Damping Factor	30
Input Sensitivity	150mV (line)
Power Output	100W per channel (8 ohms, 20Hz-20kHz, 0.9% THD)
Impedance	8 ohms
Dimensions	430 x 158 x 370mm
Speaker Load Impedance	8Ω to 16Ω
Video Connections	Composite Video