Technics SA-DA10 - AM Tuner Performance; Amplifier Performance Metrics

file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p01.htm
MONO 73 dB
STEREO 67 dB
Frequency response 20 Hz-15 kHz,+1 dB, -2 dB
Alternate channel selectivity 65 dB
Capture ratio 1.5 dB
Image rejection at 98 MHz 40 dB
Spurious response rejection at 98 MHz 75 dB
AM suppression 50 dB
Stereo separation
1 kHz 40 dB
10 kHz 30 dB
Antenna terminal
75Ω (unbalanced)
AM Tuner Section
Frequency range 530-1710 kHz
Sensitivity 20•V, 330•V/m
Selectivity 55 dB
IF rejection (at 1000 kHz) 50 dB
Video Section
Output voltage at 1 V input (unbalanced) 1±0.1 Vp-p
Maximum input voltage 1.5 Vp-p
Input/output impedance
75Ω
Amplifier Section
Rated minimum sine wave RMS power output
20 Hz-20 kHz both channels driven
0.09% total harmonic distortion
100 W per channel (6Ω)
1 kHz continuous power output both channels driven
0.05% total harmonic distortion
105 W per channel (6Ω)
Total harmonic distortion
rated power at 20 Hz-20 kHz
0.09% (6Ω)
half power at 1 kHz
0.03% (6Ω)
Power bandwidth
both channels driven, -3 dB
10 Hz-70 kHz (6Ω, 0.9%)
Power output at the DVD 6CH operation
20 Hz-20 kHz (each channels driven)
0.09% total harmonic distortion
Front
2 x 100 W (6Ω)
Center
100 W (6Ω)
Surround
2 x 100 W (6Ω)
Low frequency damping factor
30 (6Ω)
Load impedance
Front
A or B
4 - 8Ω
A and B
8Ω
BI-WIRE
6 - 8Ω
Center
6 - 8Ω
Surround
6 - 8Ω
file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p01.htm (2 of 3) [21/01/2007 13:46:55]