Technics SA-EH560 - Operation Checks and Component Replacement Procedures

6 Operation Checks and Component
Replacement/Procedures
TOP PREVIOUS NEXT
This section describes procedures for checking the operation of the major printed circuit boards and
replacing the main components.
For reassembly after operation checks or replacement, reverse the respective procedures. Special
reassembly procedures are described only when required.
/
6.1 Checking for the AC IN P.C.B.
6.2 Checking for the operation P.C.B.
6.3 Checking for the main P.C.B.
6.4 Replacement for the regulator transistor
6.5 Replacement for the power IC
•@
TOP PREVIOUS NEXT